1NEW®  Silicone Gasket Makers  are formulated to repair and replace gaskets that need to withstand high temperatures up to  650оF (343оС). Ideally suited for repair and replacement of almost all possible car gaskets.  Resists motor oils and cracking, shrinking and migrating caused by thermal cycling.

INSTRUCTIONS:

1.  Remove old gasket and clean thoroughly surface from old material, oil and dirt.

2.  Remove can and puncture cartridge seal and screw on nozzle and cut to desired bead size.

3.  Apply continuous and even bead of silicone to one surface around perimeter surrounding bolt holes. Wait 10 minutes to allow silicone to dry.

4.  Reassemble parts.

5.  After use replace cap.

 NOTE: 

Leave thickness for gasket when reassembling. Do not over-tighten bolts. Silicone dries to touch in 10-20 minutes. Allow 24 hours to fully cure and bond.

CAUTION:

In case of skin or eye contact flush with warm water. KEEP OUT OF REACH OF CHILDREN.  

Net weight: 85 g.

Made in China under license from and control by 1NEW®  TRADE, INC.

Part No. 12-NEW